AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
*/mppe required,stateless/' /tmp/pptpd/options.pptpd" but routing packets trough a WAN interface without being encrypted is stupid. Hostname in this example will be set to ""īasically we're telling "If you want to access any host on the 192.168.1.x subnet please forward your packet trough the router at the IP address "192.168.1.1".Set Router Name and Host Name to "dd-wrt-02".NOTE: This will force all PPTP clients to use encryption. Set Password to "PPTP_CLIENT_PASSWORD_SITE02".Set Username to "PPTP_CLIENT_USERNAME_SITE02".This router will have the role of "node". ![]() ![]() The following information was provided by forum member crushedhat:įurther info on this subject can be found here and here You should increase this if more routers will be bridged.UPDATE: If you are just trying to get IPv6 working (6to4) on v24 sp1, please view this page: In the example the IP range used for VPN clients were "192.168.1.200-201" thus 2 VPN clients are allowed to connect to our concentrator.The IP address pool for VPN clients must be outside the range of DHCP clients.The router's subnets should not intersect each other (i.e. UPDATE: For Eko's v24 TNG build 14583 you will need 2.4.37 ip6tables modules. Since “working for me” can mean anything, I’m posting exactly what I needed to do to get IPv6 working for me. More detail about many of these steps can be found in the wiki and other docs. ![]() I’m running this variant so that I’ll have some JFFS space for packages: I’m using Eko’s v24 TNG build 9856 on my Buffalo WHR-HP-G54 (4MB flash). I see that the IPv6 kernel module and the radvd daemon are in the build, and that the Administration/Management panel provides a few IPv6 options.
0 Comments
Read More
Leave a Reply. |